Agri-Fab 45-02102-101 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Agri-Fab 45-02102-101에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-02102-101 16 페이지. 125 lb. push broadcast spreader
Agri-Fab 45-02102-101에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)
페이지 인쇄22. Place the adjustable stop into the "ON" end of
the slot in the top of the flow control mounting
bracket. Secure with the 1/4" x 3/4" carriage bolt,
a nylon washer, a 5/16" flat washer and the ny-
lon wing nut. See figure 11.
NYLON
WING NUT
5/16" FLAT
WASHER
NYLON
WASHER
FIGURE 11
ADJUSTABLE
STOP
1/4" x 3/4"
CARRIAGE BOLT
23. Position the flow control mounting bracket
(Refer to figure 12).
a. Push on flow control arm until it locks in "OFF"
position.
b. Slide flow control mounting bracket along tube
until closure plate in bottom of hopper just
closes.
c. Snug the 1/4" lock nuts just enough to hold
flow control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control
arm against stop. Verify that closure plate has
opened about half way.
e. If closure plate does not open half way, it may
be closed too far at "OFF". Adjust position of
flow control mounting bracket until closure
plate will open about half way at "5" and still
close when arm is locked in "OFF". Tighten
1/4" lock nuts.
FIGURE 12
7
AJDUSTABLE
STOP
SETTING "5"