Aussie Monsoon 100 사용 설명서 - 페이지 6
{카테고리_이름} Aussie Monsoon 100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aussie Monsoon 100 16 페이지. Monsoon series
페이지 인쇄Aussie Pumps
FRAME & WHEEL CARE .... MAINTAIN OPTIMUM PERFORMANCE
Aussie Monsoon blasters now come
fitted with top quality flat free tyres.
To maintain tyre shape ...
1. Ensure that straps used to secure
the unit during transit are not over
tightened to the point where tyres
misshape.
Before proceeding with assembly of your new Aussie
Eco AB high pressure blaster, check that all parts
listed below are included.
1 Gun with melted handle
1 Vario lance
1 High pressure hose
1 Grit blast kit
A.
Machine Preparation (initial start-up)
1. Check the oil in the pump.
With the machine on a level surface the oil lever
should cover the red spot in the oil level sight glass
on the front of the machine. If necessary, top up
with SAE 75W-90. Do not mix different grades of
oil as this may affect the machines performance. If
alternative oil is used, first empty out oil by
unscrewing drain plug in bottom of machine.
Breather plug
Pump oil sight glass
Aussie Monsoon Single Phase Blasters ... Operation & Maintenance Manual
6
2. Do not leave the unit strapped
down for extended periods.
3. Do not drop the unit; this could
cause frame distortion or damage
bearings.
ASSEMBLY & PREPARATION FOR USE
2. Ensure breather plug is fitted to pump.
WARNING: Before operation ensure top mounted
travel plug is replaced by breather plug. Failure to
fit breather and keep clean can result in over
pressuring of oil chamber (crank case) and can
blow oil seals. This will void warranty.
3. Plug in machine to suitable power supply.
NOTE: Unit supplied with a 15 amp plug. A 10
amp plug can be retro fitted but the pump pressure
will need to be adjusted down to reduce amps
drawn by the motor. This should only be done by a
qualified technician.
4. Assemble gun/lance assembly.
VARIO LANCE: To assemble the lance, insert lance
into gun and screw together.
March 2018