Datatool DT201 사용 설명서 - 페이지 11
{카테고리_이름} Datatool DT201에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datatool DT201 15 페이지.
페이지 인쇄Troubleshooting
If the DT201 does not react to the remote control when arming or disarming check the
following:
•
LED Indicator is illuminating on the remote when the Arm/Disarm button is pressed.
If not replace the remote control battery.
•
Operate the remote directly adjacent to the motorcycle in case of local radio
frequency (RF) interference.
•
If a local source of RF interference is identified, move the motorcycle away from the
area and attempt to operate the DT201 again.
• It is important that the internal battery in the DT201 is not left in a discharged condition.
• If the DT201 internal battery is left discharged it will result in damage to the battery.
• If the motorcycle is to be left unused for any period beyond two weeks it should be
connected to an appropriate battery conditioner to maintain good battery condition.
• Battery issues resulting from improper maintenance are not covered under warranty.
Customising the System
The DT201 has been designed to be simple to operate and to allow certain features to be
programmed to suit personal preference or requirements. The user programmable options are:
•
Arm/Disarm tones – quiet, loud or off (default)
•
Automatic Rearming - on or off (default)
•
Passive Arming at ignition off – activate at 30 seconds, 60 seconds or off (default)
•
Battery type – lead acid (default) or lithium ion
NOTE: Sensitivity movement can only be adjusted by an installing dealer, due to Thatcham
approval requirement.
Programming Guide
To adjust the arm/disarm tone
1.
Disarm the DT201.
2.
Turn on the ignition.
3.
Within 10 seconds, press and hold both buttons on the remote control.
4.
After 3 seconds the DT201 will start to chirp loudly. Release the remote control buttons
after the first chirp, if you miss the correct chirp wait for the alarm to exit programming
mode after the seventh chirp or turn off the ignition a loud chirp will be given to indicate
programming has been exited.
5.
Once programming mode is entered the DT201 will bleep a specified number of times
to indicate the current setting, the LED will flash the current setting repeatedly.
6.
Press the Arm/Disarm or Programming button on the remote control to cycle through
the tone options:
•
Off (1 Bleep) (Default)
•
Quiet (2 Bleeps).
Scorpion House, Drumhead Road, Chorley North Business Park, Chorley, Lancashire, England. PR6 7DE
Tel: +44 (0) 1257 249928 E mail:
CAUTION
Datatool is a brand of Scorpion Automotive Ltd
DT201 Operation Guide Revision 1 24-07-2023
Web: http://www.datatool.co.uk
9