Datatool DT201 사용 설명서 - 페이지 9
{카테고리_이름} Datatool DT201에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datatool DT201 15 페이지.
페이지 인쇄If the DT201 is disarmed with ignition off, then pressing and holding the Arm/Disarm button
for 3 seconds will first arm the DT201 before triggering the Panic Alarm.
If the DT201 is in the armed state, then pressing and holding the Arm/Disarm button for 3
seconds will disarm the DT201 before triggering the Panic Alarm feature. If the Arm/Disarm
button is pressed a second time to stop the Panic feature the alarm will always reset to the
disarmed state regardless of the previous state.
Battery Monitoring
The DT201 monitors the motorcycle battery voltage and, when the DT201 is armed, flashes
the motorcycle instrument LED at a variable rate to notify the measured battery voltage. The
LED flash rate is as follows:
Lead Acid Battery
1
Measured Voltage
Greater or equal to 11.5 V
Between 11.5V and 10.5 V
Less than or equal to 10.5 V
1
Voltages are approximate
2
If the movement sensor is disabled, either by use of Transport Mode or via programming
then the status LED will flash twice in quick succession to indicate that the movement sensor
has been disabled, if the movement has been permanently disabled via programming the
indicators flash three times on arming and if arm/disarm tones are enabled, three chirps will
be heard.
Lithium Battery
1
Measured Voltage
Greater or equal to 13.2 V
Between 13.2V and 12.4 V
Less than or equal to 12.4 V
1
Voltages are approximate
2
If the movement sensor is disabled, either by use of Transport Mode or via programming
then the status LED will flash twice in quick succession to indicate that the movement sensor
has been disabled, if the movement has been permanently disabled via programming the
indicators flash three times on arming and if arm/disarm tones are enabled, three chirps will
be heard.
Optional Supplementary Siren Output
The DT201 allows for the addition of an optional second siren using the Optional
Supplementary Siren Output, if used with a suitable siren this can increase the output volume
when the alarm is sounding.
Alternatively, the output can be connected to a pager input, allowing a notification to be
received on your pager device in the event of an alarm trigger occurring.
If you would like to use the Optional Supplementary Siren output feature speak to your
installing dealer.
Scorpion House, Drumhead Road, Chorley North Business Park, Chorley, Lancashire, England. PR6 7DE
Tel: +44 (0) 1257 249928 E mail:
2
LED Sequence
Once every 5 seconds
Once every 10 seconds
Once every 20 seconds
2
LED Sequence
Once every 5 seconds
Once every 10 seconds
Once every 20 seconds
Datatool is a brand of Scorpion Automotive Ltd
DT201 Operation Guide Revision 1 24-07-2023
Indicative Status
Fully charged battery
Partially discharged battery
Low battery
Indicative Status
Fully charged battery
Partially discharged battery
Low battery
Web: http://www.datatool.co.uk
7