AUSSIE TONNEAU ATB01340 피팅 지침 - 페이지 2

{카테고리_이름} AUSSIE TONNEAU ATB01340에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSSIE TONNEAU ATB01340 3 페이지. Great wall v200 / v240 dual cab with sport bar

6. To fit bar brackets measure 695mm back from the inside front

edge at the top of the tub (5mm down from top edge of tub).

See Figure 3

7. Drill and rivet using two large rivets for each Bar Bracket. Install

support bar according to supplied instructions.

8. To fit round body hooks measure 175mm down from the inside edge and line up each hook individually to

each bunji loop starting with the two either side of the tailgate handle and working your way around to

the front, drill and rivet buttons alternating from side to side. See Figure 4

2. CARING FOR YOUR TONNEAU

Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's waterproofing

ability and prevent the stitching from degrading. Use a mild detergent and soft scrubbing brush to clean tonneau.

Never drive without tonneau support bars in place as flapping can cause a delaminating effect on the material.

3. MULTI-FIT SUPPORT BAR

The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys

to Cab Chassis aluminium trays.

2.1 BASIC TOOL REQUIRED

Drill, 4mm drill bit

"Tonneau is not designed to be used as a load restraint"

Figure 4

Figure 3