AUSSIE TONNEAU ATB01340 Instrukcja montażu - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Akcesoria samochodowe AUSSIE TONNEAU ATB01340. AUSSIE TONNEAU ATB01340 3 stron. Great wall v200 / v240 dual cab with sport bar
Drukuj stronę6. To fit bar brackets measure 695mm back from the inside front
edge at the top of the tub (5mm down from top edge of tub).
See Figure 3
7. Drill and rivet using two large rivets for each Bar Bracket. Install
support bar according to supplied instructions.
8. To fit round body hooks measure 175mm down from the inside edge and line up each hook individually to
each bunji loop starting with the two either side of the tailgate handle and working your way around to
the front, drill and rivet buttons alternating from side to side. See Figure 4
2. CARING FOR YOUR TONNEAU
Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's waterproofing
ability and prevent the stitching from degrading. Use a mild detergent and soft scrubbing brush to clean tonneau.
Never drive without tonneau support bars in place as flapping can cause a delaminating effect on the material.
3. MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys
to Cab Chassis aluminium trays.
2.1 BASIC TOOL REQUIRED
-
Drill, 4mm drill bit
"Tonneau is not designed to be used as a load restraint"
Figure 4
Figure 3