Aussie Traveller SUNBURST ECLIPSE 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Aussie Traveller SUNBURST ECLIPSE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aussie Traveller SUNBURST ECLIPSE 5 페이지.

ROLL UP PROCEDURE

1. Lower both right and left support arms to the

dome nut position using the lift handle and trigger.

Lower one end 50% then the other fully and then

the first one fully.

2. Loosen knob on rafter. Lower rafter by depressing

lever on the outside of the frameset leg which

will allow the slider to be released. Slide rafter to

bottom of support arm. Repeat on other arm.

3. Slide pull strap to the right until ratchet lever is

within reach.

4. Grasp pull strap, and by pulling out, release the

pressure on the ratchet lever. Locate ratchet lever

behind roller and rotate lever upwards and forward

towards the front of the awning.

If ratchet lever is difficult to operate, use pull strap

to rotate roller slightly as if to slacken fabric further.

This reduces tension on mechanism and lever.

1300 663 868 | [email protected] | aussietraveller.com.au

BRISBANE SHOWROOM: 11-15 Oasis Court, Clontarf QLD 4019 | MELBOURNE SHOWROOM: 235 Barry Road, Campbellfield VIC 3061

5. Slide pull strap more towards the centre of awning.

Use pull strap to control speed of awning when

rolling back towards R.V.

To avoid creating a bulge in awning fabric allow

strap to roll up diagonally side by side across roller

and fabric.

6. Lock both support arms in travel position. To lock

squeeze rafter and top support arm together rotate

travel locks behind rafters.

7. Tighten black knurl knobs. Ensure roller does

not move when pull strap is given a slight tug.

This confirms the ratchet mechanism is working

correctly.

WARNING: The awning is under tension and can

snap back against the vehicle. To avoid damage

to awning or vehicle, DO NOT release ratchet lever

without holding pull strap.