ADE M703600-01 운영 매뉴얼 - 페이지 7

{카테고리_이름} ADE M703600-01에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE M703600-01 12 페이지. Electronic lifter scales

페이지 인쇄

Once Backlight is set on, scale never turns off backlight,

independent from stability.

Press

to exit the Settings Mode.

Symptom

blank display by pressing

On/Off

no action taken after TARE or

HOLD is activated

unstable readings

Scale does not show zero

without load

substantial error in weight

result

Cleaning:

For cleaning just use a damp cloth or common disinfection products.

Do not use any aggressive cleaning fluids.

Warranty – Liability:

ADE will repair or replace this product within a period of 1 year from date of delivery applying to

defects occurred due to poor material or workmanship (presentation of invoice is necessary). All

moveable parts – batteries, cables, mains units, rechargeable batteries etc. – are excluded. Warranty

does not include natural wear, damages caused by incorrect or negligent handling, overuse or

unsuitable or improper storage. The cost of transport will be borne by the customer should the

equipment be located anywhere other then the customer's premises. In the event of transport

damage, claims under warranty can be accepted subject to using the complete original packaging and

the equipment secured the way it was packed and secured originally. All the packaging should

therefore be retained.

Any warranty claim will be rejected if the equipment is opened by persons not authorized expressively

by ADE to do so.

To make sure the scale is fully reliable at any time do check the scale in regular intervals by using

tested weights.

M703600+M703600-01-210817-Rev008-UM-en

Trouble-shooting & Cleaning

Possible reasons

discharged battery

defective battery

defective ON/OFF key

defective TARE or HOLD key

scale in motion

scale is damped

dust on PCB board

unstable power system

load-cell stressed too much or

for too long

Scale has been loaded before

zero setting process has been

finished

re-calibration needed

improper unit

Possible actions

replace battery

press ON/OFF key for long

clean TARE or HOLD key

stabilize the load and scale

dry the scale

clean PCB board

increase warm-up time

hang the scale during storage

keep the scale unloaded and

start procedure again and wait

for zero setting before loading

re-calibrate the scale

switch to proper unit