ADE M70611 운영 매뉴얼 - 페이지 2

{카테고리_이름} ADE M70611에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE M70611 5 페이지. Electronic lifter scale

Your ADE scale is a quality product. In order to achieve best possible results please follow strictly the

instructions of this Operating Manual:

Check carton contents

Electronic Lifter Scale

2 Safety hooks (1 snap link, 1 stable S-hook)

3 x AAA Batteries

Operating Manual

Insert batteries

Open the battery compartment on the backside of the scale by sliding the lid aside.

Insert 3 x AAA Batteries respecting the pole markings.

Shut the battery compartment carefully and make sure it is completely closed.

In case display shows 'LO' batteries are flat and need to be replaced.

Installation of scale to a suitable patient lifter

Insert the snap link into the upper the S-hook into the lower suspension of the scale.

Remove the suspension yoke of the patient lifter and replace this by using the upper

suspension eye of the scale to combine lifting arm and scale.

Slide the suspension respectively the carrying equipment of the patient lifter carefully into the

S-hook.

Display symbols and function keys

Underneath the display you are finding the following 3 keys:

ON/OFF to start the scale and turn it off.

ZERO/TARE to set the scale back to zero.

UNIT key to change the weighing mode. You have the option to weigh either in kg or lb.

Weighing

To achieve a reliable result make sure the scale in always in vertical position. The S-hook must not yet

be loaded by any weight.

Now press the ON/OFF key to start the scale. After a short function test the measuring becomes

stable, the scale found its zero position and enters the '0.00' kg mode.

Installation and use of scale

060100-Rev000-M70611