DVIGear DVI-TPS-RX95-HD 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} DVIGear DVI-TPS-RX95-HD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DVIGear DVI-TPS-RX95-HD 8 페이지. Dvi tps extender
페이지 인쇄DVI TPS Extender
1. Status Indicator LEDs
HDCP
VIDEO SIGNAL
LINK
LIVE
2. NORMAL / PROG
3. LR / AUTO
4. Remote PWR Jumper A remote power settings jumper is located on the side of the unit - see page 4.
5. IR IN/OUT
6. DVI IN/OUT
7. TPS IN/OUT
8. Ethernet IN/OUT
9. 12 VDC IN
10. RS-232 IN/OUT
Note 1: These units enter Low Power Partial Functionality (LPPF) Mode when no signal is detected on the input.
Normal operation is restored when a signal appears on the input. LPPF is not supported with Long Reach Mode.
WARNING: Ethernet ports are designed to connect to 10/100 BaseT Ethernet products only.
Do not connect any device to the TPS connector unless you are sure they are compatible.
Connecting incompatible devices with similar connectors may cause harm to the devices.
Installation: Stand-Alone Operation
1.
Remove power from all devices (installing devices while powered may cause damage).
2.
Set the RS-232 switches on the front panels of the TX and RX to the Normal position.
3.
Set the TPS link mode with the LR / AUTO switch on the front of the units (see page 5).
4.
Set the TX remote power mode
5.
Connect a CAT-X twisted pair cable to the TPS OUT on the transmitter unit.
6.
Set the RX remote power mode
7.
Connect the other end of the CAT-X twisted pair cable to the TPS IN on the receiver unit.
8.
Connect a DVI or HDMI signal source to the DVI IN port on the transmitter unit.
9.
Connect a DVI or HDMI display device (e.g. projector) to the DVI OUT on the receiver unit.
Quick Start Guide
Lit Continuously
HDCP-encrypted video
signal transmission
Video signal transmission
TPS connection detected and
HDBaseT or LR Link Mode
—
Set the RS-232 switch to the NORMAL position. The PROG position is only
for use by qualified technical personnel.
Use these switches to toggle between TPS link modes - see page 5.
Connect the IR Transmitter to IR OUT. Connect the IR Receiver to IR IN.
Connect the source device to DVI IN. Connect the display to DVI OUT.
Use a high quality TP cable to connect TPS OUT to TPS IN - see warning below.
Connect to Ethernet switch and/or devices - see warning below.
Connect AC Power Adapter to TX and/or RX. Settings vary - see page 4.
Connect to Ethernet switch and/or devices - see Installation.
(2)
(2)
Blinking
TPS connection detected
and LPPF Link Mode
Device powered and
ready to use
with the jumper on the side of the TX (see page 4).
with the jumper on the side of the RX (see page 4).
DVI-TPS-TX95-HD
DVI-TPS-RX95-HD
No HDCP encryption
—
No video signal
—
transmission
TPS connection failed
(1)
between TX and RX
No power supply
present or malfunction
Off
3