DVIGear DVI-TPS-RX95-HD 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} DVIGear DVI-TPS-RX95-HD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DVIGear DVI-TPS-RX95-HD 8 페이지. Dvi tps extender

페이지 인쇄

DVI TPS Extender

TPS Link Modes

The TPS 95 Series extenders provide user selection of three different modes for the TPS connection.

HDBaseT

Long Reach (LR)

Low Power Partial

Functionality (LPPF)

Note 5: For available resolutions and extension distances, see Maximum Cable Lengths table below.

Toggling Between TPS Link Modes

Both TX and RX have a TPS Link Mode toggle switch with two settings: Auto and LR. If either unit is

set to LR, both of them switch into LR mode. If both units are set to Auto and there is a valid video

signal on the transmitter, the TPS Link Mode will be HDBaseT. If the video signal is not active, the

devices go into Low Power (LPPF) mode. LPPF mode is not available while using LR mode.

Mode

HDBaseT / LPPF

If a TPS 95 Series extender and an MXP Series TPS I/O board are paired, the board will force the extender

to use the settings of the matrix. In this case, the extender's TPS Link Mode switch has no effect.

Note 6: Always use Auto Mode and disable remote power operation when paired with third-party devices.

Maximum Cable Lengths

Clock

Resolution

Freq.

1920x1080p

148.5 MHz

@60Hz / 24bpp

1920x1200

152.9 MHz

@60Hz

1600x1200

162.0 MHz

@60Hz

4096x2160

297.0 MHz

@30Hz

Note 7: Long Reach Mode supports DVI or HDMI signals with pixel clock rates up to 148.5 MHz.

Note 8: CAT6A S/FTP (550 MHz) 23AWG twisted pair cable must be used to achieve these distances.

Quick Start Guide

Supports higher data rates, but limits maximum extension distances. In this mode, if there

is no active video, the units will automatically switch to Low Power (LPPF) TPS link Mode.

Supports greater extension distances, but does not support DVI or HDMI signals with a pixel clock

rate greater than 148.5 MHz. The Low Power (LPPF) mode is not available while in this mode.

While in HDBaseT Mode, if there is no active video signal, the units will automatically switch

to Low Power (LPPF) mode. This mode only supports Ethernet, RS-232 and IR signals.

Transmitter

Receiver

Does not matter

Auto

CAT-5e (AWG 24)

HDBaseT

330 ft.

(~100 m)

330 ft.

(~100 m)

330 ft.

(~100 m)

230 ft.

(~70 m)

Long Reach

(7)

425 ft.

(~130 m)

400 ft.

N/A

400 ft.

N/A

400 ft.

N/A

330 ft.

DVI-TPS-TX95-HD

DVI-TPS-RX95-HD

CAT-6A (AWG 23)

HDBaseT

Long Reach

(~120 m)

600.0 ft.

(~120 m)

(~100 m)

(8)

(7)

(~180 m)

N/A