Datcon DT1600 U Series 사용 설명서 - 페이지 13

{카테고리_이름} Datcon DT1600 U Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datcon DT1600 U Series 20 페이지. Ac voltage transmitters

DT1600 Ux xx xx

Wiring plan, connecting

the signal processing

unit and the power

supply

(see also "Application

example")

Be careful the polarity of

the cables

Checking the

connections

Put the instrument

under supply voltage

20180621-V0

5.3. Connecting the signal processing unit and the

power supply

The following figure shows the wiring plan, connecting the

signal processing unit and the power supply:

1. Loosen terminal screws.

2. Insert the wire ends into the open terminals according to

the wiring plan.

3. Screw the terminal in.

4. Check the hold of the wires in terminals by pulling on

them firmly.

Check if the cables are connected properly (have you

connected all the cables, have you connected to the right

place, do not the cable-ends touch each other).

After you have completed the connections, put the

instrument under supply voltage. If the connection is correct

the green indicator give light and you can measure output

current or voltage on the output of the instrument according

to the measured value of the transmitter.