Datecs INFINEA X 사용자 설명서 - 페이지 13

{카테고리_이름} Datecs INFINEA X에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datecs INFINEA X 14 페이지.

1 DATECS InfineaX

User manual

4.6 Clearing Bluetooth pairing info

- Hold on same time status and rear speaker button until the device is beep twice, if after

that the devices is still not showing on iOS device available for connecting press on same

"battery status" and "scan" button for ~5sec.

*Note: If after Bluetooth paring info clearing, InfineaX is not visible, perform with "Reset

InfineaX" (4.11)

- For changing active speaker, press speaker switching button.

When the rear speaker is active, blue led is light.

- When the battery level is above 3,9V – InfineaX is automatically start to charge iPhone5 or

iPod5. (If the option is enabled in settings)

- This function can be enabled or disabled

- This function can be enabled or disabled

- Holding on same time status and scan button for ~5sec

The InfineaX uses a scan engine that supports one-dimensional (1D) and two-dimensional

(2D) barcode symbols. The effective reading distance of the barcode reader varies

depending on the barcode size.

Scanning Barcodes:

To scan a barcode fist activate the scanner. Then position the scan head to center the

red aiming laser near the center of the barcode and the illumination box is over the outer

edges of the barcode.

Slowly pull back the unit increasing the distance between the barcode and scan head until

the barcode has been read by the scanner.