4qd Uni-4-12 사용 설명서 - 페이지 4
{카테고리_이름} 4qd Uni-4-12에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4qd Uni-4-12 8 페이지.
페이지 인쇄The controller must be mounted suitable housed to
protect it from the weather and from inadvertent
contact with foreign bodies, so the use of the correct
cover is advocated.
The controller mounts via the heatsink as shown in
the diagram, right. Mounting will normally be onto a
metal plate which will act as heatsinking.
Steel is not a good heat conductor -you should use
aluminium or even copper.
Make sure the controller cannot get wet: normally
when mounted as shown and correctly covered water
cannot get onto the circuit board, and water on the
base will do no harm. Make sure water cannot run
down the wires into the controller.
The diagram shows the simplest connections needed to use the controller.
More detailed information on wiring follows.
Page 4
Mounting
Connections
Permanent
magnet
motor
Heatsink mounting holes are tapped M3 and spaced
at 25.4mm (1").
The integral heatsink is isolated.
Black
Blue
Yellow not used
Red - max
Blue - wiper
Green or Black - min
Yellow
Red
Red
Min
Max
Uni Instructions