Austin Kontore Leopold Bench Kit 조립 설명서 - 페이지 7

{카테고리_이름} Austin Kontore Leopold Bench Kit에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Austin Kontore Leopold Bench Kit 12 페이지. Children's version

Using a 1/8" drill bit, drill (3) holes on each leg assembly.

REPEAT for both leg assemblies.

Important: Only drill a hole about 2" deep – you don't

want to drill all the way through the Front Leg.

Three (3) 2 ½" deck screws hold the Rear Leg to the Front

Leg. You'll need (6) screws in total to make the two leg

assemblies.

Using your screwdriver, fasten the Rear Leg to the Front

Leg with (3) screws.

Important: Make sure the angles look right, that the

"feet" of the legs are flat against your straight edge, and

that both finished leg assemblies are mirrors of each

other.

Once the legs are screwed together, you can test them by

standing them up. They may tip a bit, but the bottom

("feet") of the leg assemblies should be flat against the

floor, and the Rear Legs should be mounted at the same

height as each other.

REPEAT for both leg assemblies.

Page 7 of 12