Datron DBS-4500 - REV A 매뉴얼 - 페이지 11
{카테고리_이름} Datron DBS-4500 - REV A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datron DBS-4500 - REV A 18 페이지. In-motion satellite television system land version
페이지 인쇄6.
Troubleshooting
Error conditions are described in Table 1 and possible solutions are indicated for each symptom. If
you have trouble and cannot resolve it with this guide, contact your Datron dealer or Datron/Transco
Inc. at 1-800-287-5052.
Symptom
Does not
No screen display
acquire
" INIT-REV XXXX"
does not display on
monitor
" INIT-REV XXXX"
continuously
displayed on monitor
" Searching for
Satellite"
continuously
displayed on monitor
Table 1. Error Conditions and Solutions
Indication
Cause
Switch not turned on
Battery dead
Power not
connected to battery
Antenna not
connected
Bad switch
Monitor not turned
on
Receiver not turned
on
ACU not connected
Receiver not
connected
Excessive motion
View is obstructed
Antenna coax not
connected
Radome covered
with debris
Initialized during
excessive motion
Radome covered
with dew
M-01335, Rev. A
Page 9
Possible Solution
Turn on switch
Recharge/replace
battery
Connect power to
battery
Connect missing/loose
cable
Replace switch
Turn on/plug in monitor
Turn on/plug in receiver
Connect missing/loose
cable
Connect missing/loose
cable
Normal operation;
reduce vehicle motion
Move vehicle to new
location
Connect all cables
Clean radome
Stop motion during
initialization
Spray radome with hose,
or wipe excess moisture
from radome, or drive
vehicle to remove
moisture coating