Datron DBS-4500 - REV A 매뉴얼 - 페이지 13

{카테고리_이름} Datron DBS-4500 - REV A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datron DBS-4500 - REV A 18 페이지. In-motion satellite television system land version

페이지 인쇄

6.1

Failure Messages

Failure messages are described in Table 2. If any of these messages are displayed, contact your

nearest Authorized Service Center or call Datron directly at (800) 287-5052.

Failure Messages Displayed

on Screen

CODE: 01 AZ & EL

CODE: 02 AZIDX

CODE: 03 ELIDX

CODE: 04 A2D

CODE: 05 XRATE

CODE: 06 YRATE

CODE: 07 ZRATE

CODE: 08 PLEVL

CODE: 09 RLEVL

CODE: 10 LNBFV

Precautions

Do not open or remove any part of the antenna control unit or the antenna/radome assembly.

There are no user serviceable parts inside.

Operate the antenna system on a clean, continuous 12 VDC supply only. Fluctuations in voltage

can

degrade

performance.

CONNECTION.

To locate the authorized dealer nearest you, f you are in need of assistance, contact Datron/Transco

Inc. Customer Service Department at 1-800-287-5052.

Turn antenna system OFF after acquiring signal if vehicle is to be stationary for a long time. Power

off will reduce power drain and extend operating life of antenna and vehicle battery.

Table 2. Failure Messages

Reason for Message Display

Both AZ and EL index

switches/motors failed.

AZ index switch/motor failed.

EL index switch/motor failed.

Fault in the analog-to-digital

converter.

X gyro rate sensor failed.

Y gyro rate sensor failed.

Z gyro rate sensor failed.

Pitch level sensor failed.

Roll level sensor failed.

Failure of the R-hand/L-hand

polarity of the LNBF.

OBSERVE PROPER POLARITY ON THE POWER

M-01335, Rev. A

Possible Solution

Contact nearest Authorized

Service Center or call Datron

at (800) 287-5052

Repair or replace coax

Check receiver voltage to

LNBF

Page 11