AUSTRALIAN MONITOR TX8202 운영 매뉴얼 - 페이지 5
{카테고리_이름} AUSTRALIAN MONITOR TX8202에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN MONITOR TX8202 11 페이지. 8 channel 1 ru mixer
AUSTRALIAN MONITOR TX8202에 대해서도 마찬가지입니다: 사양 (2 페이지), 사양 (2 페이지)
페이지 인쇄
Dual RCA Stereo Line Inputs
The top connectors are for the Left channel auxiliary inputs while the bottom connectors are for the Right
channel auxiliary inputs. Reading from Left to Right across the rear panel, the connections are for auxiliary
inputs 8, 7, 6 and 5.
XLR Microphone/Line Inputs
Each XLR input is switchable to be either balanced mic or line (via an internal dip switch, the
location and setting of which is explained in the 'Internal Adjustments' section of this manual).
When set to mic level, the mic input sensitivity is 1mV ( for a 1 Volt output). When set to line
level, the input sensitivity is 330 mV (for a 1 Volt output). Pin connections are: pin #1-earth; pin #2-active
(high, +); pin #3-active (low, -). Phantom power of +15 volts is available on all 4 XLR inputs. An internal
phantom power ON-OFF switch is provided for each channel. The default setting is ON (See the 'Internal
Adjustments' section of this manual for more details).
Direct Outputs
A unique feature of the TX8202 is the individual direct output available for each of the first 4
channels. The direct outputs are accessed via balanced TRS 1/4" sockets for each channel. The
level of each output is 1 Volt (nominal). Internal jumpers (JP1) allow signal from any of the first
six channels to be disconnected from the main left/right outputs (See the 'Internal Adjustments' section of
this manual for more information). The direct outputs are adjustable to be pre or post the channel level
control. Factory default setting is post fader.
Vox Muting
Priority muting is provided for channels 1 and 2. Both channels have equal priority and will mute
channels 3-8 when signal is present. The muting function may be disabled by moving the jumper
labeled JP2 (located on the pcb behind the channel 8 volume control). ON and OFF positions are
clearly indicated on the pcb beside the jumper. The unit ships from the factory with muting enabled (JP2 -
OFF) – that's right, OFF; it is a muting disable function, not a muting enable function. When channels 1
and 2 are disconnected from the main left/right outputs, the muting function is automatically disabled.