austriamicrosystems AS5130 운영 매뉴얼 - 페이지 5
{카테고리_이름} austriamicrosystems AS5130에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. austriamicrosystems AS5130 8 페이지. Programmable high speed magnetic rotary encoder
페이지 인쇄AS5130 8 bit high speed magnetic rotary encoder
Demoboard Operation Manual
Red: Out of range
Reverse Sensor Direction:
Change direction between "clockwise" and "counter clockwise"
Low Power:
Set the device into "sleep mode"
Wakeup:
Wake up the device from sleep mode
2.5
OTP
The "OTP" tab, displays the OTP configuration bit of the selected AS5130 sensor.
•
In Onboard mode, the configuration bits can be temporary changed (access to the Read and Write
functions only). After a new power up, the configuration bits are set back to their default state.
•
In External mode, the AS5130 can be temporary configured, and can be permanently programmed
too. The Read, Write and Prog functions are available.
Zero Position Programming:
The Zero Position Programming tool is used to assign a zero value to a defined mechanical position.
Move the magnet to a desired reference position, which is the mechanical 0°.
Click on "Get absolute position". The actual angle seen on the sensor side is displayed in decimal
and binary (Z7..0 bits).
Click on "Write zero position". The bits Z7..0 are written to the Zero Position register of the AS5130.
Now the actual mechanical angle is the 0° angle on the AS5130 side.
This value can be permanently fused on an external AS5130 sensor by clicking on Prog.
OTP registers:
In On-board mode, the OTP registers can't be permanently fused.
•
Read: Reads back the OTP configuration registers of the selected sensor.
•
Write: Writes the configuration bits as represented in the checkboxes to the selected AS5130. Those bits
won't be permanently written, and will be lost if the sensor is powered down.
Revision 1.0, 01-June-08
Figure 5: OTP tab
www.austriamicrosystems.com
Page 4 of 7