austriamicrosystems AS5130 운영 매뉴얼 - 페이지 6
{카테고리_이름} austriamicrosystems AS5130에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. austriamicrosystems AS5130 8 페이지. Programmable high speed magnetic rotary encoder
페이지 인쇄AS5130 8 bit high speed magnetic rotary encoder
Demoboard Operation Manual
•
Prog (external mode only): After having written the configuration bits to the AS5130, those bits can be
permanently fused by clicking on Prog. After a new power up of the device, this new configuration is
enabled.
Test Polling Mode:
After clicking the button "Test Polling mode" the current angle will be stored and VDD disabled. By changing the
angle, a wake-up signal will be generated and the VDD will be enabled again, without changing the angle, no wake
up signal will be generated automatically and the devices goes to normal mode.
By setting the bit "Wake enable" , a signal to the Expansion connector will be send.
Enable Sin/Cos Setting: by setting this bit, a new tab will be opened – but without function!!
3 AS5130 Demoboard hardware
Figure 6: AS5130_DB_1.0 Demoboard schematics
3.1.1
Power supply
The demoboard is powered directly from the USB plug of a PC or from an external DC power supply (>7.5V, 100mA)
connected on the DC jack J6 and regulated through a 5V voltage regulator (I1, ZR78L05).
The programming high voltage (8.5V) for the external AS5130 is generated directly from the 5V source through a DC/DC
step-up converter U3. This source is used for the LCD power supply as well, for the contrast control through the P1
potentiometer.
The U2 voltage regulator is necessary for the 3.3V LCD power supply.
Revision 1.0, 01-June-08
www.austriamicrosystems.com
Page 5 of 7