austriamicrosystems AS5163 운영 매뉴얼
{카테고리_이름} austriamicrosystems AS5163에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. austriamicrosystems AS5163 6 페이지. 14 bit programmable magnetic angle position encoder
austriamicrosystems AS5163에 대해서도 마찬가지입니다: 운영 매뉴얼 (6 페이지)
페이지 인쇄AS5163
14 bit Programmable Magnetic Angle Position Encoder
1 General Description
The AS5163 is a contactless magnetic angle position
sensor for accurate angular measurement over a full turn
of 360°. A sub range can be programmed to achieve the
best resolution for the application. It is a system-on-chip,
combining integrated Hall elements, analog front end,
digital signal processing and best in class automotive
protection features in a single device.
To measure the angle, only a simple two-pole magnet,
rotating over the center of the chip, is required. The
magnet may be placed above or below the IC.
The absolute angle measurement provides instant
indication of the magnet's angular position with a
resolution of 0.022° = 16384 positions per revolution.
According to this resolution the adjustment of the
application specific mechanical positions are possible.
The angular output data is available over a 14 bit digital
2 The AS5163 Demoboard
The AS5163 demoboard is a complete rotary encoder system with built-in microcontroller and graphical LCD display.
The board is externally supplied with a 9V battery for standalone operation.
J6: External
Encoder
Connector
External (left) – Onboard (right)
encoder selection switch S2
Figure 1: AS5163 Demoboard hardware with mounted magnet knob
Revision 1.0, June 2009
protocol, a 12 bit PWM signal or 12 bit ratiometric analog
output.
The AS5163 operates at a supply voltage of 5 V and the
supply and output pins are protected against overvoltage
up to +27 V. In addition the supply pins are protected
against reverse polarity up to – 18 V.
LCD display (for standalone mode)
Onboard AS5163 output signals connector and indicators
Vout, Kick down and GND
www.austriamicrosystems.com
AS5163-DB-1.0 Demoboard
OPERATION MANUAL
9V battery connector
(standalone only)
SiLabs C8051F342
microcontroller on
the back
Knob with D5x2.5mm
diametral magnet,
2mm over the AS5163
Page 1 of 6