austriamicrosystems AS1109 매뉴얼 - 페이지 4

{카테고리_이름} austriamicrosystems AS1109에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. austriamicrosystems AS1109 8 페이지. White goods demo board 64 leds, i2c interfaced led driver with keyscan

페이지 인쇄

AS1115 - Demo Board Manual

White Goods

Software

To use the AS1115 White Goods Demoboard a controller is required. The controller can be connected to the

demoboard via the I/O Connector "D".

If no controller is available the austriamicrosystems USB box in combination with the AS1115 White Goods

Demoboard software can be used as well. This USB box is needed to set-up the connection between the

demoboard and the USB interface of a PC. The USB box can be ordered via http://www.austriamicrosystems.com.

The AS1115 Demoboard is controlled via the software and the board is only working in connection with software.

The condition of the LED's (ON or OFF) or the different buttons can be triggered via the software or directly on

the board.

Picture 1: Software Panel

Note:

As a first step make sure that the hardware connection between the PC and the Demoboard via the

austriamicrosystems USB box is set.

The second step is to connect the software to the board. For this go to the USB menu and click on "connect" (see

Picture 2: Software Panel detail). If the USB sign on the right lower side (see Picture 1: Software Panel) is turned

to green the software is correct linked to the demoboard.

Picture 2: Software Panel detail

www.austriamicrosystems.com

Revision 1.04

4 - 7