AFCO 175 Series 설치 지침

{카테고리_이름} AFCO 175 Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AFCO 175 Series 4 페이지. Level cable rail

페이지 인쇄

Series 175

Series 175 AFCO

INSTALLATION INSTRUCTIONS

PARTS INCLUDED:

TOP RAIL—TOP RAIL (1)

(2)

SADDLE BRACKET

SUPPORT BLOCK CONNECTOR

TOOLS REQUIRED:

Drill bit

" (.156")

5/32

Drill Bit 9/32" (.281)

Drill bit 29/64" (.453)

1/8" hex wrench

7/16" wrench

Drill (with adjustable clutch, recommended)

Miter Saw (with metal cutting blade)

Level

Rubber mallet

Tape measure

Cable cutters

Grinder with cutoff wheel

Touch-up paint

FOR A SUCCESSFUL INSTALLATION:

Read the instructions completely before beginning the installation.

Plan your railing project. Sketch your project with the actual measurements of your deck or balcony

complete with post locations.

Check local building codes to ensure compliance.

Check carton(s) to determine part count is complete.

After cutting rails, balusters, or posts, paint exposed metal for maximum protection against the elements.

Installation is best accomplished with two people.

Wear personal protection equipment; safety glasses, etc.

Use care not to over-torque the screws. Pre-drilling is recommended.

Provided hardware to install AFCO-Rail is for use with Aluminum AFCO-Rail posts. If installing to other

surfaces the installer must acquire the appropriate hardware as needed for proper installation.

AFCO–

–

Level Cable Rail

(2)

BRACKET COVER

(2)

#10

SELF DRILLING SCREW

BOTTOM RAIL— BOTTOM RAIL (1)

B D

(2)

BOTTOM BRACKET

3 1/2 "

(1)

(12)

DRIVER BIT

PRE

DRILLED CABLE BALUSTER

NOTES:

NOTE: Cables for this rail system are sold

separately.

Posts packaged separately.

An Optional AFCO-Tool is available to simplify the

locating, pre-drilling and installation of

brackets.

10"

(1)

SUPPORT BLOCK

(1)

ADHESIVE TAB SHEET