AFCO 175 Series 설치 지침 - 페이지 4

{카테고리_이름} AFCO 175 Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AFCO 175 Series 4 페이지. Level cable rail

INSTALLATION INSTRUCTIONS CONTINUED

9. Apply adhesive tab (J) to flat surface of Top Rail (A) near the post. Slide

Bracket Cover (D) to interlock with the flange on the saddle bracket.

10. Screw self-drilling screws (H) into the Top Rail (A) from the underside of

each Saddle Bracket ( C ) through the provided locating hole to securely fasten

the rail.

CABLE INSTALLATION

1. Drill out and enlarge the holes in the outermost wall

with a 9/32" drill bit through the holes already in the post, and also drill the

only

outermost wall

on the opposite end of the cable run with a 29/64" drill bit.

This step is to allow the cable fittings to be installed.

2. Remove cable and fittings from packages and install the required washer

and brass nut on the threaded stud end of the cables, and feed the bare ends

of the cable through all posts and support balusters starting at the holes drilled

out to 9/32".

3. Slide Line Fittings with required round black washers onto the cables while

twisting in a clockwise motion until the fittings are fully seated in the end post.

Pull the bare ends to remove as much slack as possible. Trim all ends of the ca-

ble sticking out of the fittings with a cutoff wheel and press the cap onto the

fittings.

4. Return to the treaded stud end of the cables and starting with the

centermost cable insert a 1/8" hex wrench into the end of the treaded stud.

Tighten the locknut with a 7/16" wrench while holding the hex wrench to

prevent the cable from turning.

5. It is recommended that you follow the sequence of tensioning the cables

starting at the center and alternating above and below until all cables are

properly tensioned. As cables are tensioned give a sharp pull downward

mid-span to set the fitting wedges, then re-tension as necessary in the same

sequence.

6. When all cables are tight, cut off any exposed threads near the locknut as

possible using a cut-off wheel or hacksaw. Press the nut cap over the

locknut.

AFCO INDUSTRIES, INC., P.O. BOX 5085, ALEXANDRIA, LA 71307

For more information, contact Customer Service at 1-800-599-9912 or visit our website at www.afco-ind.com.

only

of the first post

PAGE 4

AFCO Form AR21 Rev. 2/2018