aFe Power 440-401006-N 사용 설명서 - 페이지 5
{카테고리_이름} aFe Power 440-401006-N에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aFe Power 440-401006-N 13 페이지. Heavy rate racing sway bar pillow mounts
페이지 인쇄
End Link Assembly
Assemble each of the end links as shown below. The end of the turnbuckle with left hand
threads is denoted by the incomplete wrench flats. Adjust two of the end links to
approximately 90 mm for the front sway bar and two of them to approximately 80 mm for
the rear sway bar. It is not necessary to tighten the jam nuts at this time.
End Link
Length
Install Front End Links
Install one of the 90mm long end link assemblies onto each of the front lower control
arms. Use a 15mm open end wrench on the flats of the heim joint stud to prevent it from
rotating as you tighten the nut using an 18mm socket. Torque to76 N-m (56 ft-lbs).
OTE: To prevent thread galling, do not use a high-speed driver such as an
impact gun on the flange nut. Only tighten by hand and torque to spec.
5
00P-0T1027-A