aFe Power 440-401006-N Manuale di istruzioni - Pagina 5
Sfoglia online o scarica il pdf Manuale di istruzioni per Automobile Accessories aFe Power 440-401006-N. aFe Power 440-401006-N 13. Heavy rate racing sway bar pillow mounts
Stampa la pagina
End Link Assembly
Assemble each of the end links as shown below. The end of the turnbuckle with left hand
threads is denoted by the incomplete wrench flats. Adjust two of the end links to
approximately 90 mm for the front sway bar and two of them to approximately 80 mm for
the rear sway bar. It is not necessary to tighten the jam nuts at this time.
End Link
Length
Install Front End Links
Install one of the 90mm long end link assemblies onto each of the front lower control
arms. Use a 15mm open end wrench on the flats of the heim joint stud to prevent it from
rotating as you tighten the nut using an 18mm socket. Torque to76 N-m (56 ft-lbs).
OTE: To prevent thread galling, do not use a high-speed driver such as an
impact gun on the flange nut. Only tighten by hand and torque to spec.
5
00P-0T1027-A