4tronix Ultimate Initio kit 매뉴얼 - 페이지 11
{카테고리_이름} 4tronix Ultimate Initio kit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4tronix Ultimate Initio kit 11 페이지. For raspberry pi
페이지 인쇄
The main build of your Ultimate Initio Kit for the Raspberry Pi is now
complete.
6. Connecting the Wheel Sensors (Optional)
Note that the wheel sensors require additional code to operate properly that is not included in
the python library.
It is recommended that you do not fit these until you are familiar with the operation of the
rest of the robot.
If you want to fit them, use Pins 15 and 16 (marked x15, x16 or #22, #23 and note that the
silk screen on the board has these swapped over)
For each Wheel Sensor, connect:
Black to Gnd
•
Red to 5V
•
Orange or Brown to the selected pin (in fact, each wheel has 2 sensors that are slightly
•
out of phase so you can get direction of travel from them, but you will then need 2
pins for each sensor)
It is recommended to leave the wheel sensor cables unconnected to start with