4tronix Ultimate Initio kit 매뉴얼 - 페이지 9
{카테고리_이름} 4tronix Ultimate Initio kit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4tronix Ultimate Initio kit 11 페이지. For raspberry pi
페이지 인쇄
Connect the Pan servo (bottom servo) to Pin 22 (marked x22 or #25)
Connect the Tilt servo (upper servo) to Pin 18 (marked x18 or #24)
Note the colours of the servo wires and ensure they are connected correctly:
Black: Gnd
•
Red: 5V
•
Orange or White: Signal
•
5. Connecting the Ultrasonic Sensor
For this you will need the mounting plate, saddle clamp and the final 2 of the 2.0x6PB screws
used in step 4
Push the 4-way 30cm female-female cable that you made in Step 3 onto the top of the
ultrasonic sensor:
Brown: Gnd
•
Red: Echo
•
Orange: Trig or Ping
•
Yellow: 5V or VCC
•