ADE Optima G3 사용 설명서 - 페이지 2
{카테고리_이름} ADE Optima G3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE Optima G3 17 페이지. Intruder alarm system
페이지 인쇄
Operating instructions
System installation
This booklet tells you how to operate your
intruder alarm system. To simplify this booklet
we have assumed that the alarm system has been
installed by a professional intruder alarm system
installer (the installer), and that the system is
operated in a "typical" way. Aspects of your
system that are not "typical" will be described
by your installer.
"
If you have any questions
about your intruder system, then
consult your installer, see contact
details on the front page.
Codes
To operate the alarm system you will need to
use a code. A code is 4 digits long, and can be
any number from 0000 to 9999. By default the
0
1
2
code is
change this as soon as possible.
Alarm System Operation
This booklet describes two versions of the alarm
system. The Optima version has the keypad and
indicators on the main control panel. The
Accenta version has the keypad and indicators
on a small remote keypad. You operate the
alarm system by pressing buttons on the keypad
and viewing the indicators. Both alarm systems
work the same way. Both Accenta and Optima
systems can be fitted with an optional remote
keypad.
Personal Attack
If you are under threat, or are being attacked,
you can activate the alarm by pressing the 4 and
9 keys at the same time on any keypad. The
alarm system will produce a loud alarm sound,
and the external siren will be turned on.
2
3
but you should
Fire Zones
One or more Zones on your alarm system may
have a Fire or Smoke detector connected to it. In
the event of a fire the alarm system will produce
a distinctive two-tone fire alarm sound, and the
outside siren will pulse 2 seconds on, 2 seconds
off. You should leave the premises immediately,
and only re-enter when it is safe to do so. The
alarm can be silenced by entering your code.
Power Indicator
The Power indicator on the control panel or
keypad will light whenever the mains power
supply is present. If mains power fails then the
Power indicator will go out, but the system will
run from its backup battery for several hours. If
the Power indicator goes out when mains power
is present then a fault may have developed on
your system and you should contact your
installer.
Warning beeps
Your system may produce warning beeps to
inform you of a potential problem. A single beep
every 5 minutes tells you that the system needs
to be serviced. You should call your installer to
arrange a service visit. The system will continue
to operate correctly in all respects.
A double beep every 5 minutes tells you that the
telephone line that the alarm system uses is not
available or has failed. This may be due to
someone using a telephone on the same line. If
this problem persists you should contact your
installer to rectify the problem. Your alarm
system will continue to operate, but it cannot
send alarm messages via the telephone line.
Signalling Device
Your alarm system may have been fitted with a
signalling device. This device uses the telephone
line to send an alarm message to an Alarm
Receiving Centre in the event of an alarm. The
operator at the ARC may request the police to
attend your premises.