Bretford 35XTC14 조립 지침 - 페이지 4

{카테고리_이름} Bretford 35XTC14에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bretford 35XTC14 5 페이지. Adjustable work center with cpu holder and casters 30" depth only, 36"/42"/48" wide one/two grommet hole

페이지 인쇄

Attach the CPU bracket with the square hole located on the bottom flange first. Install with washers (KK) and

screws (LL) as shown.

NOTE:

Wrap tape around an 1/8" dia. drill

bit at 3/4" for drilling depth.

tape

Determine the overall width of your cpu. Place the other CPU bracket over the mounted CPU bracket as shown.

Adjust the space between the two brackets by sliding the bracket side to side to equal your cpu width. MAKE

SURE THAT THE BRACKETS ARE PARALLEL. Using the CPU bracket as a template, mark the two hole

locations for drilling pilot holes. Carefully drill an 1/8" dia. pilot holes 3/4" deep (see note above). Install the

second bracket with washers (KK) and screws (LL).

NOTE:

The table is predrilled so the first cpu bracket can

mount on the left or right side of your table

Step 5

Step 6

square hole

width of monitor

(inside dimension of

CPU brackets)

mark two hole locations