Bretford 35XTC14 Assembly Instructions - Page 4

Browse online or download pdf Assembly Instructions for Indoor Furnishing Bretford 35XTC14. Bretford 35XTC14 5 pages. Adjustable work center with cpu holder and casters 30" depth only, 36"/42"/48" wide one/two grommet hole

Print Page
Attach the CPU bracket with the square hole located on the bottom flange first. Install with washers (KK) and
screws (LL) as shown.
3"
NOTE:
4
Wrap tape around an 1/8" dia. drill
bit at 3/4" for drilling depth.
tape
Determine the overall width of your cpu. Place the other CPU bracket over the mounted CPU bracket as shown.
Adjust the space between the two brackets by sliding the bracket side to side to equal your cpu width. MAKE
SURE THAT THE BRACKETS ARE PARALLEL. Using the CPU bracket as a template, mark the two hole
locations for drilling pilot holes. Carefully drill an 1/8" dia. pilot holes 3/4" deep (see note above). Install the
second bracket with washers (KK) and screws (LL).
NOTE:
The table is predrilled so the first cpu bracket can
mount on the left or right side of your table
Step 5
KK
LL
Step 6
square hole
LL
KK
width of monitor
(inside dimension of
CPU brackets)
mark two hole locations