BENDIX AD-IS - 매뉴얼 - 페이지 10

{카테고리_이름} BENDIX AD-IS -에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENDIX AD-IS - 17 페이지. Air dryer and reservoir system
BENDIX AD-IS -에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 서비스 데이터 (15 페이지)

페이지 인쇄

CLEANING & INSPECTION

1. Use a suitable solvent to clean all metal parts, and use

a cotton swab to clean the bore (Note: Do not use

abrasives or tools to clean the bore: any scratches

caused may necessitate replacing the AD-IS

and reservoir system.) Superficial external corrosion

and/or pitting is acceptable.

2. Clean the o-rings with a clean dry cloth. Do not use

solvents.

3. Inspect for physical damage to the bore and the check

valve seat. If the bore is damaged (by scratches etc.

that would prevent delivery check valve from seating),

replace the AD-IS

air dryer.

4. Inspect the delivery check valve, o-rings, etc. for wear or

damage. Replace if necessary using the check valve

replacement kit available at authorized Bendix parts

outlets.

5. Inspect all air line fittings for corrosion and replace as

necessary.

ASSEMBLY

1. Lubricate the smaller o-ring and check valve body with

Bendix supplied barium or silicon grease.

2. Install this o-ring on the check valve body by sliding the

o-ring over the set of 4 tapered guide lands. The

o-ring groove holds the o-ring in its correct location.

3. At the other end of the check valve body, the spring is

installed over the set of 4 straight guide lands. When

the spring has been pushed to the correct location, the

check valve body is designed to hold the end of the spring

in position - be sure that the spring is not loose before

continuing with this installation.

4. Install the assembled check valve body/o-ring/spring in

the delivery port so that the o-ring rests on its seat and

the free end of the spring is visible.

5. Grease the adapter and the remaining larger o-ring and

install it onto the fitting.

6. Position the Bendix supplied gasket, then insert the

governor mounting bolts through the governor and tighten

(to 125 in-lbs). (Note: Do not replace with a standard

compressor/governor gasket.)

7. Reattach line to the governor.

8. Before placing vehicle back into service, check to see

that the system pressure now builds to full operational

pressure.

air dryer