dymax PC-3 운영 매뉴얼 - 페이지 9

{카테고리_이름} dymax PC-3에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dymax PC-3 20 페이지. Ultra uv curing light source
dymax PC-3에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

1. Install lamp per LAMP REPLACEMENT/INSTALLATION (Page 9).

2. Connect power cord to rear of unit and plug into a grounded wall outlet.

3. Connect light guide to bezel mount by pressing down on lock and inserting guide.

4. Press power switch. Button will illuminate when power is on.

5. Allow lamp to warm up for 4-5 minutes to obtain maximum light output.

6. Locate foot switch where desired. (Electric shutter)

7. Operate shutter by pressing foot switch. With the timer selector switch in the manual

position, the shutter operates directly from the foot switch. In the timed position, the shutter

opening is determined by the setting of the potentiometer; clockwise increases the opening

time and the foot switch must be released after each cycle.

THIS IS AN ARC, NOT A FILAMENT LAMP. ONCE IGNITED, IT MUST BE LEFT ON FOR A

MINIMUM OF 5 MINUTES TO FULLY VAPORIZE ELEMENTS IN THE LAMP. IF NOT, THE

LAMP MAY BE DIFFICULT TO REIGNITE.

The lamp must cool before it can be reignited. Leave power switch on should the lamp

extinguish. This operates the cooling fan and allows the lamp to relight when it has cooled

sufficiently. If the lamp fails to ignite, refer to pages 11-14, TROUBLESHOOTING.

Lamp life is reduced approximately one hour each time the lamp is switched on and off. Avoid

repeated cycles by leaving unit on through breaks.

TM-021 PN 35933

Rev 05/06/97

CAUTION

NOTE