BENE P2 안전 및 작동 지침 매뉴얼 - 페이지 7
{카테고리_이름} BENE P2에 대한 안전 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENE P2 12 페이지. Monitor lift
페이지 인쇄SAFETY INSTRUCTIONS
21. Do not spill liquids into the control unit
or power supply unit, as this could cause
electrical shock or short circuits.
22. The operation of the control mechanism
and the power supply unit requires a
minimum of 5°C and a maximum
temperature of 40°C.
23. For the above reasons do not install the
control unit:
- above or in front of heat sources
(e.g. radiators)
- at places exposed to direct sunlight
- in small, unventilated or humid rooms
- near easily flammable materials
- near high-frequency devices
(e.g. transmitters, radiation equipment,
or similar devices)
Warning: In the event of a fault it is
possible that the table top moves a bit
during every attempt whilst operating
before the safety switch off kicks in.
Please take care to avoid the possible
danger of crushin.
Warning: During all reset procedures
(section 5) the collision protection is
not active. Please take care to avoid
possible danger of crushing.
Please note: Please note: If the product
is visibly damaged it must not be
installed or used further.
24. After 1 minutes of continuous operation
the system automatically shuts itself off
and cannot be used for an additional
9 minutes. This keeps the motor from
overheating.
7