BENE P2 Посібник з техніки безпеки та інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з техніки безпеки та інструкція з експлуатації для Підйомні системи BENE P2. BENE P2 12 сторінок. Monitor lift

Друкувати сторінку

SAFETY INSTRUCTIONS

21. Do not spill liquids into the control unit

or power supply unit, as this could cause

electrical shock or short circuits.

22. The operation of the control mechanism

and the power supply unit requires a

minimum of 5°C and a maximum

temperature of 40°C.

23. For the above reasons do not install the

control unit:

- above or in front of heat sources

(e.g. radiators)

- at places exposed to direct sunlight

- in small, unventilated or humid rooms

- near easily flammable materials

- near high-frequency devices

(e.g. transmitters, radiation equipment,

or similar devices)

Warning: In the event of a fault it is

possible that the table top moves a bit

during every attempt whilst operating

before the safety switch off kicks in.

Please take care to avoid the possible

danger of crushin.

Warning: During all reset procedures

(section 5) the collision protection is

not active. Please take care to avoid

possible danger of crushing.

Please note: Please note: If the product

is visibly damaged it must not be

installed or used further.

24. After 1 minutes of continuous operation

the system automatically shuts itself off

and cannot be used for an additional

9 minutes. This keeps the motor from

overheating.