BENE P2 Посібник з техніки безпеки та інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з техніки безпеки та інструкція з експлуатації для Підйомні системи BENE P2. BENE P2 12 сторінок. Monitor lift

Друкувати сторінку

CAPACITIVE MANUAL SWITCH

The capacitive manual control switch is operated by touching

the wood surface directly in front of the lift column flap.

Before starting the system, you must reset the control unit.

Reset:

Tap five times, and after the fifth time leave your finger on

the surface until the lift column reaches the bottom positi-

on. When it reaches the bottom position there will be a beep

signal. The device is now ready for operation.

Up:

Tap twice, and after the second tap leave your finger on the

surface until the monitor moves in the desired direction. The

lift column automatically moves to the top position.

Down:

Tap twice, and after the second tap leave your finger on the

surface until the monitor moves in the desired direction. The

lift column automatically moves to the lower position.

Stop:

Tap once – the lift column stops. The down/up function swit-

ches after each stop.

AUTOMATICALLY TURNING THE MONITOR ON AND OFF:

Connect the coupler provided in the assembly package to the

control unit to automatically activate it.The power supply is

activated ca 50 mm above the lowest monitor position. The

power supply remains activated as long as the monitor is at

least 50 mm below the highest monitor position. The control

unit deactivates the power supply after one minute due to

safety reasons, if the monitor lift is not fully extended (e.g.

only half upward lift) to avoid heat accumulation and resulting

damage to the device.