GABOR TM-SS 사용자 설명서 - 페이지 9

{카테고리_이름} GABOR TM-SS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GABOR TM-SS 12 페이지. Tilting wall mount for small flat-panel displays

Attaching the Wall Bracket to Concrete

Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick. If

the concrete exhibits cracks or other defects, this may result in failure of the concrete

anchors and cause serious personal injury or damage your display.

Place the wall bracket up to the location marked for your display, and use a pencil to mark the four drilling holes needed

for the concrete anchors. Use the included bubble level to make sure the bracket is level before drilling.

Use a 3/8-inch (10 mm) concrete drill bit to predrill the marked spots 2.4 inches (60 mm) deep, and then clean out the

debris from the holes.

Insert the concrete anchors into the predrilled holes, and use a hammer to tap the anchors into the concrete.

Attach the bracket to the wall by inserting the anchor screws through the washers and the wall brackets' mounting

holes, and screw them into the anchors until secure. Use the wrench to further tighten the anchor screws, but do not

overtighten. Use the included bubble level to make sure the bracket is level.

TM-SS / TILTING

/ SMALL

WALL MOUNT

3/8-inch

2.4 in.