GABOR TM-SS Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Стойки и подставки GABOR TM-SS. GABOR TM-SS 12 страниц. Tilting wall mount for small flat-panel displays
Печатать страницу
Attaching the Wall Bracket to Concrete
Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick. If
the concrete exhibits cracks or other defects, this may result in failure of the concrete
anchors and cause serious personal injury or damage your display.
1.
Place the wall bracket up to the location marked for your display, and use a pencil to mark the four drilling holes needed
for the concrete anchors. Use the included bubble level to make sure the bracket is level before drilling.
2.
Use a 3/8-inch (10 mm) concrete drill bit to predrill the marked spots 2.4 inches (60 mm) deep, and then clean out the
debris from the holes.
3.
Insert the concrete anchors into the predrilled holes, and use a hammer to tap the anchors into the concrete.
4.
Attach the bracket to the wall by inserting the anchor screws through the washers and the wall brackets' mounting
holes, and screw them into the anchors until secure. Use the wrench to further tighten the anchor screws, but do not
overtighten. Use the included bubble level to make sure the bracket is level.
G
H
I
J
4X
4X
4X
1X
TM-SS / TILTING
/ SMALL
WALL MOUNT
2
3/8-inch
2.4 in.
9