Dymo LabelManager Wireless PnP 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Dymo LabelManager Wireless PnP에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LabelManager Wireless PnP 13 페이지. Dymo labelmanager wireless pnp technical datasheet
Dymo LabelManager Wireless PnP에 대해서도 마찬가지입니다: 기술 데이터 시트 (7 페이지), 개요 (12 페이지), 빠른 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
- 1. Quick Start
- 2. Inserting the Battery
- 3. Inserting the Label Cassette
- 4. Connecting the Label Maker to Your Computer
- 5. Starting the Built-In Software
- 6. Disconnecting the Label Maker from Your Computer
- 7. Maintaining Your Label Maker
- 8. Recharging the Battery
- 9. Cleaning the Label Maker
- 10. Troubleshooting
Inserting the Label Cassette
Your label maker uses DYMO D1
label cassettes.
To insert the label cassette
Open the side cover of the
1
label maker.
Make sure the tape and ribbon are
2
taut across the mouth of the cassette
and that the tape passes between
the label guides.
If necessary, turn the ribbon rewind
spool clockwise to tighten the ribbon.
Insert the cassette and press firmly
3
until the cassette clicks into place.
See Figure 5.
Close the side cover of the
4
label maker.
Connecting the Label Maker to your Computer
The label maker connects to your computer using the USB connection located on
the back of the label maker. You do not need to install additional software or drivers
to use the label maker with your computer.
To connect the label maker to your computer
Plug the USB cable into the USB port on the
1
back of the label maker. See Figure 6.
Plug the other end of the USB cable into an
2
available USB port on your computer.
The label maker must be connected to a
NOTE
powered USB port. The label maker may not charge or function properly when
connected to a non-powered USB port, such as those on some Mac keyboards, or
a non-powered USB hub.
Label
guides
Ribbon
rewind spool
Figure 4
Figure 5
Figure 6
3