Dymo LabelManager Wireless PnP Hızlı Başlangıç Kılavuzu - Sayfa 5
Etiket makinesi Dymo LabelManager Wireless PnP için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dymo LabelManager Wireless PnP 13 sayfaları. Dymo labelmanager wireless pnp technical datasheet
Ayrıca Dymo LabelManager Wireless PnP için: Teknik Veri Sayfası (7 sayfalar), Genel Bakış (12 sayfalar), Hızlı Kılavuz (2 sayfalar), Hızlı Başlangıç Kılavuzu (17 sayfalar)
Sayfayı Yazdır
- 1. Quick Start
- 2. Inserting the Battery
- 3. Inserting the Label Cassette
- 4. Connecting the Label Maker to Your Computer
- 5. Starting the Built-In Software
- 6. Disconnecting the Label Maker from Your Computer
- 7. Maintaining Your Label Maker
- 8. Recharging the Battery
- 9. Cleaning the Label Maker
- 10. Troubleshooting
Inserting the Label Cassette
Your label maker uses DYMO D1
label cassettes.
To insert the label cassette
Open the side cover of the
1
label maker.
Make sure the tape and ribbon are
2
taut across the mouth of the cassette
and that the tape passes between
the label guides.
If necessary, turn the ribbon rewind
spool clockwise to tighten the ribbon.
Insert the cassette and press firmly
3
until the cassette clicks into place.
See Figure 5.
Close the side cover of the
4
label maker.
Connecting the Label Maker to your Computer
The label maker connects to your computer using the USB connection located on
the back of the label maker. You do not need to install additional software or drivers
to use the label maker with your computer.
To connect the label maker to your computer
Plug the USB cable into the USB port on the
1
back of the label maker. See Figure 6.
Plug the other end of the USB cable into an
2
available USB port on your computer.
The label maker must be connected to a
NOTE
powered USB port. The label maker may not charge or function properly when
connected to a non-powered USB port, such as those on some Mac keyboards, or
a non-powered USB hub.
Label
guides
Ribbon
rewind spool
Figure 4
Figure 5
Figure 6
3