Dymo LabelPOINT 350 사용자 설명서 - 페이지 3

{카테고리_이름} Dymo LabelPOINT 350에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LabelPOINT 350 17 페이지. Electronic label maker
Dymo LabelPOINT 350에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 빠른 시작 (4 페이지)

페이지 인쇄

About Your New Labelmaker

With your new DYMO ExecuLabel

labelmaker, you can create a wide variety of high-

quality, self-adhesive labels. You can choose to

print your labels in many different sizes and styles.

The labelmaker uses DYMO D1 label cassettes in

widths of 6 mm (1/4"), 9 mm (3/8"), 12 mm (1/2"),

or 19 mm (3/4"). Label cassettes are also available

in a wide range of colors.

Visit www.dymo.com for information on obtaining

labels and accessories for your labelmaker.

Warranty Registration

Please complete the warranty registration card and

return it to the appropriate Customer Support

address within seven days. Visit www.dymo.com

for details.

Getting Started

Follow the instructions in this section to print your

first label.

Connecting the Power

The labelmaker is powered by standard batteries,

an optional, rechargeable battery pack, or an AC

power adapter. To save power, the labelmaker will

automatically turn off after two minutes of inactivity.

Inserting the Batteries

The labelmaker uses six AA alkaline batteries.

To insert the batteries

1. Remove the battery compartment cover. See

Figure 2.

™

LP350

2. Insert the batteries following the polarity

3. Replace the battery compartment cover.

not be used for a long period of time.

Using the Battery Pack

An optional, rechargeable battery pack can be

used to power the labelmaker. The battery pack

can be purchased through your local DYMO

reseller.

The labelmaker must be connected to external

power through the AC adapter to charge the

battery pack. When the battery pack is completely

discharged, allow four to five hours to fully charge

the battery.

battery charging indicator may continue to display

even though the battery pack is fully charged.

To use the battery pack

1. Open the battery compartment door.

2. Insert the battery pack. See Figure 3.

Figure 2

markings (+ and –).

Remove the batteries if the labelmaker will

When connected to external power, the

Figure 3

AUS