Gacell CT-15000 사용자 설명서 - 페이지 7

{카테고리_이름} Gacell CT-15000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gacell CT-15000 13 페이지.

recovery mode for repairing old, idle, stratified or sulfated batteries.

NOT all batteries can be recovered. For optimal results, take the battery

through a full charge cycle, bringing the battery to full charge, before

using this mode. When this mode is chosen, do remember press Mode

button for choosing appropriate 12V/24V Mode(s). One REPAIR cycle can

take up to eight (8) hours to complete the recovery process and will

enter to charge (8 steps charging cycle) when completed. This mode

uses a high charging voltage and may cause some water loss in WET cell

batteries. Plus, some batteries and electronics may be sensitive to high

charging voltages. To minimize risks, disconnect the battery from the

vehicle before using this mode.

Using 13.6V SUPPLY (Hold & Press)

This mode converts the charger to a constant voltage, constant current

DC power supply. When the charger is not connected with battery, it can

be used to power 12VDC devices. Prior to use, read your 12VDC device

manual to determine if it is suitable for use with this mode. As a power

supply, it can also be used to retain a vehicle's on-board computer

settings during battery repair or replacement. 13.6V Supply Mode

provides 13.6V at 9.5A with overload protection at 10A (Max). Both

spark proof and reverse polarity protection are disabled in this mode. Do

NOT allow the positive and negative battery clamp to touch or connect

to each other as the charger could generate sparks.

Using 12V JUMP CHARGE (Press)

USE THIS MODE WITH FULL ATTENTION AS THE CHARGING CURRENT IS

20A. This mode is for 12-volt LEAD_ACID batteries only. To operate JUMP

CHARGE, the charger must be connected to a 12V battery with the

battery clamps connected. Press the Jump Charge button to begin

jumpstarting. For optimal results, allow JUMP CHARGE to complete its

5-minute charge. After 5-minute jumpcharge, the charger will

automatically enter Standby Mode, whether 100% battery level

indicator is illuminated or not, and your are ready to start your vehicle. If

unsuccessful when starting your vehicle, let the battery rest for 15

minutes and try JUMP CHARGE again. Most vehicles will start with one