Dymo LabelWriter DUO 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Dymo LabelWriter DUO에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LabelWriter DUO 8 페이지. Dymo labelwriter printer quick start
Dymo LabelWriter DUO에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지), 빠른 시작 매뉴얼 (12 페이지), 개요 (2 페이지), 사용자 설명서 (19 페이지), 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄

4. Loading Labels

The printer uses two types of labels: die-cut paper labels and D1 tape labels.

To load die-cut labels

1 Press the form-feed button to eject the labels that protected the printer during shipment.

2 Open the top cover and remove the label spool.

3 Hold the spool spindle in your left hand and place the

label roll on the spindle so that the labels feed from

underneath.

4 Place the spool guide on the right side of the spool and

adjust it to fit snugly against the roll. See Figure 7.

5 Insert the label spool into the slots in the printer cover.

6 Cut the first label in half so that you have a clean edge and insert

the label into the label feed slot. See Figure 8.

The printer feeds the labels, stopping at the beginning of the first

label. If the printer stops without feeding the label, make sure the

label is fully inserted and then press the form-feed button.

7 Close the top cover.

Figure 7

Figure 8