Adel CBI2410A 사용 설명서 - 페이지 2

{카테고리_이름} Adel CBI2410A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Adel CBI2410A 4 페이지. Intelligent battery charger

__________________________________________________Battery Charger

Rail mounting:

Other modules must have a minimum vertical distance of 10 cm to this power supply in order to guarantee sufficient auto

convection.

Use and Connections

Caution:

Switch off the system before connecting the module. Never work on the machine when it is live.

Charging Level Current: With trimmer from 20% to 100% of In. Select the max. battery charge current estimated from 10 to 25% of

the nominal capacity.

- Connection to Battery module (Output 1) 3-4 Pin: Battery Input and diagnosis led: very fast blinking= recovery charging ( when

the battery is too low) , fast blinking=fast charge, slow blinking=trickle charge

- Connection to Out Load (Output 2) 1-2 Pin: Output voltage 24 Vdc is made via the +, - .

- Monitor Mains or Backup: Mains with led off and closed contact (5-6), Backup with led on and closed contact (5-7).

Note: switching of the relay Backup should be filtered with a delay of at least 5 seconds, example: connection to PLC.

- Monitor Low Battery or Battery replacement: Normal condition with battery OK, led Off and closed contact (8-9), Low Battery with

battery NOK, led ON and closed contact (8-10), Battery replacement alarm with Power ON , led ON and closed contact (8-10); (see

diagnostic Led )

Life Test Battery : In trickle charge condition check every 4 hours, internal impedance (Battery non Ok 5 blinking Diagnosis Led)

Diagnosis Led

Very fast blinking= recovery charging ( when the battery is too low, Under 10 Vdc)

Fast blinking= fast charge.

Slow blinking= trickle charge (floating charge)

1 blinking= Reverse polarity battery; Bad input voltage battery.

2 blinking= Battery not connected.

3 blinking= Short circuit battery element.

4 blinking= Over Load.

5 blinking= Bad battery.( Internal impedance Bad or Bad battery wire connection)

Cable connection

The following cable cross-sections may be used:

At the Input: 0.2÷2.5 mm

rigid / flexible

At the Output: 0.2÷2.5 mm

Strip the connection ends: 7mm

Input: The input connection is made by the screw connections L, N, PE

NB: (BRIDGE ONLY for 115 Vac) only for 115 Vac supply

INSTRUCTION MANUAL

Assembly: pull down the plastic block with

a screwdriver, place the CB on the rail and

release the plastic block.

The CB is now assembled on the rail.

rigid / flexible

All specification are subject to change without notice

Disassembly: pull down the plastic block and pullout

the module like the arrow in the scheme

CBI2410A_R8 Eng.doc