Active Products YE03 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Active Products YE03에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Active Products YE03 10 페이지. 1450 psi electric pressure washer

페이지 인쇄

1. Parts and Diagram List

TROUBLESHOOTING

Symptom

Cause

Output pressure varies high

Discharge nozzle is obstructed.

and low. (continued)

Detergent not working.

Detergent container is empty.

Detergent bottle or suction

tube not properly connected.

Detergent is too thick.

Damaged or clogged deter-

gent suction tube.

Garden hose connection leaks.

Loose fittings.

Missing/worn rubber washer.

Spray wand, extension, or

Broken o-ring or plastic insert.

nozzle leaks.

Pump is noisy

Pump is sucking air

Water filter is clogged.

Water leaks from pump (up

Loose fittings.

to 10 drops per minute

is permissible).

Water seals are damaged

or worn.

Oil is dripping

Oil seals are damaged or

worn.

Solution

Blow out or remove debris

with a fine needle.

Add more detergent.

Check connections.

Dilute detergent.

Remove obstruction or

replace detergent

suction tube.

Tighten fittings.

Insert new washer.

Call the Toll-Free Hotline.

Check that hoses and fit-

tings are airtight. Turn off

machine and purge pump

by squeezing trigger gun

until a steady flow of water

emerges through the nozzle.

Remove water filter and

rinse in warm water.

Check that all fittings are tight.

Call the Toll-Free Hotline

TROUBLESHOOTING

Symptom

Cause

Motor buzzes but fails to run.

Supply voltage

below minimum.

System has residual pressure.

Voltage loss due to

extension cord.

Pressure washer not used

for long periods.

Residual friction among

components. Unit might

hum.

No Water

Water supply is OFF .

Kink in the garden hose.

IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, VISIT OUR WEBSITE AT

www.activeproducts.com OR CALL CUSTOMER SERVICE AT 1-866-924-7626 FOR HELP .

Solution

Verify that only the pres-

sure washer is running on

this circuit.

Turn unit "OFF" , squeeze

trigger on spray wand to

release pressure, then turn

unit "ON" .

Unplug any extension cords

attached and plug the unit

directly into the outlet.

Call the Toll-Free Hotline.

Disconnect water supply

and power ON for 2 to 3

seconds, repeat couple

times or until the motor

starts.

Turn ON water supply.

Remove kink in garden

hose.