5G HUB QCOM tool 사용자 설명서 - 페이지 6

{카테고리_이름} 5G HUB QCOM tool에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 5G HUB QCOM tool 14 페이지.

3- Connect the board to a USB cable to PC, then you shall see the ports and modem in the

Windows device manager as in this screenshot:

3 Use QCOM tool with BG96/BG95/EG91/EG95

Install the QCOM tool from this location:

5G-NB-IoT/Tools at master · 5ghub/5G-NB-IoT (github.com)

To use the QCOM tool with LTE&GNSS modem, connect the computer USB port to the USB port on

the hardware board and make sure all modem serial ports are enumerated in the Windows device

manager as in figure below.

The serial ports below can be used for the following purposes:

USB Modem: The USB modem interface is used for AT commands, data transmission, GNSS

•

data and NMEA sentences output.

•

USB AT Port: It is used for AT commands and data transmission.

•

USB NMEA Port: It is used for GNSS data and NMEA sentences output.

QCOM Tool v1.6