HHD 24S 매뉴얼 - 페이지 6
{카테고리_이름} HHD 24S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HHD 24S 14 페이지. Automatic mini incubator
페이지 인쇄
If HS is set as 38.2 and LS is set as 37.4, then the desire temperature
(incubating temperature adjustment) can only be changed from 38.2 to 37.4,
so the minimum temperature shall be limited to 37.2 even if the
pressing. The same goes for the High Set Limit.
This is to prevent accidental out of range temperature setting.
-
These are settings I have never adjusted or attempted to adjust as
-
the heating unit starts and stops within I
0
of 37.6
C.
Il . Notice for first time of
incubatin
7. Display Symbols
1. Test your incubator to see if its functions properly.
2.Connect the egg turner plug to the control plug inside the egg compartment.
Fill one or both water channels depending on local humidity levels.
3.
Set the eggs with the pointy side down.
4.
Close the lid and switch on the incubator.
5.
Press the reset button (left green button) to reset and start the day counter
6.
from O
(this will also rest the egg turning countdown back to 1:59)
Keep an eye on the humidity reading and fill the water
channels when needed. (normally every 4 days)
At day 18 you should remove the tray with the turning
8.
mechanism and place the eggs on top of he bottom grid.
At the same time it is important to fill water channels to
9.
increase the humidity. (this is very important to ensure
O
C of my set temperature
is kept on