HHD 24S Manuel - Sayfa 6

Aksesuarlar HHD 24S için çevrimiçi göz atın veya pdf Manuel indirin. HHD 24S 14 sayfaları. Automatic mini incubator

If HS is set as 38.2 and LS is set as 37.4, then the desire temperature

(incubating temperature adjustment) can only be changed from 38.2 to 37.4,

so the minimum temperature shall be limited to 37.2 even if the

pressing. The same goes for the High Set Limit.

This is to prevent accidental out of range temperature setting.

These are settings I have never adjusted or attempted to adjust as

the heating unit starts and stops within I

of 37.6

Il . Notice for first time of

incubatin

7. Display Symbols

1. Test your incubator to see if its functions properly.

2.Connect the egg turner plug to the control plug inside the egg compartment.

Fill one or both water channels depending on local humidity levels.

Set the eggs with the pointy side down.

Close the lid and switch on the incubator.

Press the reset button (left green button) to reset and start the day counter

from O

(this will also rest the egg turning countdown back to 1:59)

Keep an eye on the humidity reading and fill the water

channels when needed. (normally every 4 days)

At day 18 you should remove the tray with the turning

mechanism and place the eggs on top of he bottom grid.

At the same time it is important to fill water channels to

increase the humidity. (this is very important to ensure

C of my set temperature

is kept on