HHO Plus CCPWM60A 설치 매뉴얼 - 페이지 11
{카테고리_이름} HHO Plus CCPWM60A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HHO Plus CCPWM60A 12 페이지. Hho hydrogen on demand dual fuel generator systems
HHO Plus CCPWM60A에 대해서도 마찬가지입니다: 설치 매뉴얼 (11 페이지), 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (10 페이지)
페이지 인쇄
CCPWM60A – Installation Manual
11
Alarms
There are 2 alarms related to the amperage and electrolyte concentration:
– KOH –> This means that for the amperage set the electrolyte
concentration is too high and must be reduced. The PWM enters in
protection mode because it could burn with the conditions in place
and the regulation it must perform. There are 2 options to remove
this alarm: or you reduce the electrolyte concentration or you
increase the amperage set value.
+ KOH –> This means that the electrolyte concentration is not enough
to reach the desired amperage. You must increase electrolyte
concentration.
Water Level Sensor
The water level should be placed in a way that, when the water
level is above the minimum value, the signal coming from the
CCPWM does not return to the CCPWM. That is, the water level
circuit should operate as normally open (NO). Using our
company models, the water level sensor should be placed up
(please check last picture on this manual).
If you are not using a water level sensor in your system, no
operation is required.
If the water level drops below the minimum level then the
CCPWM will not work and a red light will appear
HHO Plus, Alternative Energies, Lta – Travessa das Serras 33, Vieira de Leiria, Portugal – Tel. 00351244697116 – Email: [email protected]