HHO Plus CCPWM60A 설치 매뉴얼 - 페이지 9

{카테고리_이름} HHO Plus CCPWM60A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HHO Plus CCPWM60A 10 페이지. Hho hydrogen on demand dual fuel generator systems
HHO Plus CCPWM60A에 대해서도 마찬가지입니다: 설치 매뉴얼 (11 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (10 페이지)

페이지 인쇄

Minimum Voltage

The CCPWM60A is designed for making the automatic power supply of the HHO System without the need for

relays or picking up the signal from the alternator/ignition key, making the system safer to use and easier to

install. In general the new CCPWM60A will work based on the voltage of the car:

- Engine is stopped – voltage in car is below 12,8V PWM => is not working;

- Engine is working – voltage in car is above 13VPWM => is working.

IMPORTANT: After having selected your voltage working limits you should test it to

check if it works correctly in your car. Stop engine and check if the CCPWM shuts

down. Start engine and check if CCPWM turns ON.

10 Water Level Sensor

The water level should be placed in a way that, when the water

level is above the minimum value, the signal coming from the

CCPWM does not return to the CCPWM. That is, the water level

circuit should operate as normally open (NO). Using our

company models, the water level sensor should be placed up

(please check last picture on this manual).

If you are not using a water level sensor in your system, no

operation is required.

If the water level drops below the minimum level then the

CCPWM will not work and a red light will appear

HHO Plus, Alternative Energies, Lta – Travessa das Serras 33, Vieira de Leiria, Portugal – Tel. 00351244697116 – Email: [email protected]

CCPWM60A – Installation Manual

The CCPWM will only work when the real car voltage value is

between the minimum and the maximum working voltage

value.

The CCPWM60A will shut down completely if the voltage drops

below 12,8V. If the voltage in the car is lower than the value

selected then the CCPWM60A will stop working and an alarm

will appear.

To set this value just proceed in the same way as explained for

the setting the amperage.